How do you find the right container for a project. How do you make the cuts and holes for the bits you want on the outside? I hate this bit… It turns a beautiful bit of neat electronics into a messy clump of duck taped rubbish…

Wow – of all the mistakes to make, I finished making the stripboard layout (again), cut all the holes, and went to put the Nano into the 2 female pin strips, and…

I’d cut the strips 1 hole too many !!! I think that I might be able to get away with it though, I might just be able to remount the 5V, GND and Vin lines which are the only ones used from the right hand side of the Nano…

Moral : measure 38 times, cut once…